Home » Gear Measurement Over Wires

Measurement over pins or wires provides a practical way to inspect tooth thickness with a micrometer. Two pins sit in opposing tooth spaces and the outside dimension is measured across them. This reference calculates even-tooth spur gear examples with one stated module, pressure angle, profile shift, and pin diameter using a manufacturer-published method.

Gear Measurement Over Wires table

MECHANITEC / ENGINEERING REFERENCE

Spur gear over-pins measurement examples

Calculated even-tooth spur gear over-pins dimensions for module-2, 20° examples using a 3.4 mm pin.

1–3 of 3 matching rows (3 total)

Search and sort apply to all 3 rows. Print and CSV include only the 3 rows shown on this page.

Why measure over pins

The method converts an internal tooth-space dimension into an external measurement a micrometer can reach. The result responds to involute tooth thickness and pin size. It is useful for production inspection when a drawing defines the expected measurement and the correct pins are available. The measured dimension is meaningful only alongside the gear geometry and inspection setup.

Inputs in these examples

Each row uses module 2, a 20° reference pressure angle, zero profile shift, and a 3.4 mm pin. Tooth count changes between examples. The calculation finds the pressure angle at the pin center through the involute function, then evaluates the even-tooth measurement. These stated assumptions make the rows reproducible rather than a general gear chart.

Involute function

For angle θ in radians, the involute function is inv θ = tan θ − θ. The manufacturer method uses this relation to find the angle associated with pin contact. Because the equation is nonlinear, the examples solve the angle numerically. Keep the trigonometric inputs in radians during calculation and convert to degrees only for display.

Select a practical pin

A theoretical ideal pin may not match stocked gauge pins. The source notes that a nearby practical diameter can be selected, and the actual diameter then belongs in the over-pins equation. A different pin changes the measured dimension. Record the calibrated pin diameter rather than substituting the ideal value after inspection.

Even versus odd tooth counts

The examples use even tooth counts and their corresponding geometry. Odd tooth counts use a different placement term. Internal and helical gears also require different arrangements or equations. Applying an even-tooth spur formula to those cases can produce a plausible-looking but incorrect reading. Confirm gear type and tooth count before calculating.

What nominal results leave out

The results represent ideal nominal geometry. They do not add profile tolerance, tooth-thickness allowance, runout, pin calibration uncertainty, temperature effects, elastic contact, or measuring force. A gear drawing may specify a target dimension with tolerance, inspection class, and datum setup. Compare a real reading with that requirement, not the rounded example.

Inspection setup

Clean tooth spaces and pins, avoid burrs, keep the instrument square to the axis, and apply consistent measuring force. Repeat the reading at multiple angular positions when runout or eccentricity matters. Record gear identity, pin size, instrument and calibration status, temperature if required, and reading spread. One measurement cannot reveal every gear error.

Use with a quality plan

Confirm module, tooth count, pressure angle, profile shift, gear type, and drawing definition before inspection. A supplier plan may call for span measurement, over pins, a gear analyzer, or another method. This reference explains a nominal calculation; it does not set acceptance criteria or certify that a part meets a gear standard.

Applying the reference

Before using a row, confirm its units, assumptions, source edition, and fit with the actual project. These values support preliminary learning and comparison; they do not replace an approved drawing, current product data, or qualified review of the actual geometry, material, and operating conditions. Keep the chosen inputs and calculation method with the design record so another engineer can reproduce the result and identify when a different model applies. Recheck the cited source when specifications or product documentation change.

Source

KHK Gears, Technical Data, Over-Pins Measurement. The table identifies sourced and calculated values. Accessed October 18, 2026.