Punch entry depth is how far a perforating punch travels into the die matrix after breaking through the sheet. Dayton Lamina gives a general target of about 0.020–0.030 inch at the bottom of the press stroke. That measurement is not the same as how far a blade penetrates sheet stock, nor is it punch-to-die clearance. Keep these dimensions separate when setting a tool.
Punch Entry Into the Die Matrix at Bottom of Stroke
Punch entry into the die matrix at bottom of stroke
Manufacturer guidance for punch travel beyond the sheet and into the matrix during perforating.
1–1 of 1 matching rows (1 total)
Free engineering resource
Unlock CSV downloads and printing
Enter your email to download the displayed table page as CSV or print it.
CSV and print access for this browser session
Submit the form to unlock CSV downloads and printing.
Search and sort apply to all 1 rows. Print and CSV include only the 1 rows shown on this page.
The reference point matters: Dayton’s value is measured when the press ram reaches the bottom of its stroke. At that position, the punch should enter the matrix only slightly. The stated range converts to 0.508–0.762 millimetre. It is a tooling guideline, not a universal die drawing dimension for every press and material.
Excess entry can increase wear and contribute to slug pulling. As the punch enters farther, the space around the slug can create suction during withdrawal. A slug that remains attached to the punch may be carried upward or interfere with the next stroke, creating production and tool-damage risks.
Entry depth should be distinguished from punch-to-matrix clearance. Clearance is the gap between the cutting edges around the punch perimeter. Entry depth is axial motion into the die after material fracture. Changing one does not directly set the other, and both must match the tool design.
It is also different from penetration through the sheet thickness. The punch must move through the stock to create the hole, but its additional travel into the matrix is a separate bottom-of-stroke setting. A chart for penetration percentage or shear clearance cannot be used as a substitute for this travel dimension.
Before setting the press shut height, confirm the punch length, die thickness, stripper travel, press stroke, bolster and tool stack. The actual point at which the punch enters the matrix depends on the assembled tooling and machine adjustment. Use the toolmaker’s layout and setup documentation as the controlling reference.
Material thickness, strength, hole size, clearance, punch geometry and slug control all affect perforating load and wear. Dayton notes that small holes relative to stock thickness change the burnish and break behavior and can raise the load. The article’s entry range does not account for those variables or authorize a particular hole design.
A spring-loaded ejector pin or air ejection may help control slugs in some tools, but those are engineering choices for the die. Confirm that any ejector system has the required travel and does not alter the intended cutting sequence. Follow the toolmaker’s guidance for the specific press and production material.
Measure the setup safely with the press isolated and according to the machine lockout procedure. Do not reach into a die area while the press can cycle. Record the verified bottom-of-stroke condition and check for slug pulling, abnormal noise, punch marks or wear during a controlled trial.
The table presents one manufacturer range and its correct interpretation. It does not claim that every die should use the same setting. If the die drawing specifies another value, or if the tooling manufacturer provides a specific setup, that approved instruction takes precedence over this general reference.
For a production problem, review entry depth together with clearance, stripper action, die alignment, punch sharpness, stock support and slug evacuation. A single dimensional change may move the symptom without correcting the cause. Consult the die designer when the observed setup differs from the approved tool documentation.
If observed slug pulling or rapid wear continues after confirming entry depth, investigate the full tool setup rather than increasing punch travel. Check die clearance, punch condition, slug evacuation, alignment and the approved setup sheet with the toolmaker.
Sources
The range and measurement condition are from Dayton Lamina’s Improving Perforating Die Performance article.

