Running and sliding fits keep a clearance between a cylindrical hole and shaft so the parts can move relative to one another. ASME B4.1 groups these fits into classes RC1 through RC9. This short index covers the closer RC1–RC4 classes and shows their hole/shaft tolerance designations. It does not reproduce the standard’s size-dependent dimensional limits; those must be selected from the current B4.1 table for the basic diameter.
ANSI Running and Sliding Fits RC1 to RC4: Class Index
ANSI running and sliding fit classes RC1 to RC4
A class index for the close sliding through close running classes in ASME B4.1.
1–4 of 4 matching rows (4 total)
Free engineering resource
Unlock CSV downloads and printing
Enter your email to download the displayed table page as CSV or print it.
CSV and print access for this browser session
Submit the form to unlock CSV downloads and printing.
Search and sort apply to all 4 rows. Print and CSV include only the 4 rows shown on this page.
The class name is a starting point, not a complete size callout. A drawing still needs a basic diameter and the corresponding limits for both mating parts. The same RC class spans nominal-size bands, and its resulting clearances change with diameter. Do not copy a clearance number from one size interval onto a different shaft or bore.
RC1 is called a close sliding fit, RC2 a sliding fit, RC3 a precision running fit and RC4 a close running fit. The matching tolerance zones are shown in the table. These designations communicate the intended fit system; they are not standalone micrometer values and do not tell a machinist the allowable diameter without a basic size.
A clearance fit is checked using the limiting sizes: minimum clearance equals minimum hole diameter minus maximum shaft diameter, while maximum clearance equals maximum hole diameter minus minimum shaft diameter. Both results should remain positive for a true clearance fit. If the signs differ, investigate the size range, tolerance direction, unit conversion or intended fit family.
Choose a closer class only when the function calls for it and the process can hold the required limits. Close fits need capable machining, reliable measurement and careful control of temperature and surface condition. A close label does not ensure smooth motion if the parts are misaligned, rough, contaminated or loaded beyond the design assumptions.
A running part also needs an operating plan. Rotation speed, bearing pressure, lubrication, heat generation, material expansion and alignment affect whether a nominal clearance remains workable in service. A fit class by itself does not establish bearing life, friction, wear rate or a safe load. Those require a separate design analysis.
For a drawing, specify the exact standard, class, basic diameter and any additional finish or geometric requirements. If a purchased bearing, bushing or shaft fixes one component’s dimensions, use the applicable system to calculate the mating part rather than assuming the hole basis is available.
Inspect actual parts at a controlled temperature with calibrated instruments suited to the tolerance. Record whether readings are maximum material, minimum material or a sampled production value. A single measurement cannot prove every point on an out-of-round or tapered part meets its limit.
ASME lists B4.1-1967 (R2020) as reaffirmed and in effect. Confirm the latest publication and contractual requirement before releasing a drawing. This page is a class index for RC1–RC4; it is not the standard itself and does not replace the numerical limit tables.
The table includes four recognized classes and their tolerance-zone pairings, while leaving out the standard’s complete numeric dimensional tables. Use the ASME publication for the selected nominal-size row, then verify both minimum and maximum clearance with the equations before manufacturing or accepting parts.
If a fit is safety-critical, subject to substantial temperature change, or expected to run at high speed or load, have the responsible engineer verify the full assembly. The result depends on the whole mechanism, not just a label in a tolerance chart.
When a class name and a numeric limit appear to conflict, stop and check the edition, basic-size interval and units before changing the drawing. The issued engineering specification controls the part; this index is only a guide to the class labels.
Sources
The fit family and current edition status are described by ASME B4.1. NIST explains fit behavior through the hole-minus-shaft gap in NIST IR 5615.
