Locational clearance fits are used when mating cylindrical parts need positional accuracy while retaining clearance for assembly or movement. ASME B4.1 identifies classes LC1 through LC11. This index covers LC1–LC5 and shows their hole/shaft tolerance-zone pairings. The numerical hole, shaft and clearance limits depend on nominal size; they are not reproduced here, so use the applicable current B4.1 size row before specifying or inspecting a part.
ANSI Locational Clearance Fit Classes LC1 to LC5: Class Index
ANSI locational clearance fit classes LC1 to LC5
A class index for five locational-clearance fit combinations in ASME B4.1.
1–5 of 5 matching rows (5 total)
Free engineering resource
Unlock CSV downloads and printing
Enter your email to download the displayed table page as CSV or print it.
CSV and print access for this browser session
Submit the form to unlock CSV downloads and printing.
Search and sort apply to all 5 rows. Print and CSV include only the 5 rows shown on this page.
A locational clearance fit differs from a running fit in its design intent. The parts are located relative to one another and the clearance is chosen to support assembly and positioning. The class label does not state a complete clearance value without the basic diameter and its associated limits.
In the hole-basis combinations shown, the hole tolerance is referenced to a hole designation and the shaft designation controls the mating zone. This provides a consistent way to describe the pair, but the tolerance symbols alone are not the finished dimensions. Convert the selected basic size through the applicable standard table.
Check the fit using the permitted extrema. Minimum clearance is minimum hole size minus maximum shaft size. Maximum clearance is maximum hole size minus minimum shaft size. For a locational clearance fit both should be nonnegative; if a calculation changes sign, review the class, size interval, deviations and unit conversion.
A smaller clearance can improve location, but it raises the importance of surface finish, roundness, alignment and assembly cleanliness. Burrs, coatings, thermal growth or a small angular misalignment can consume the available gap and make a nominally clearanced assembly difficult to install.
A larger clearance can ease assembly, but may permit more movement than the locating function allows. That movement can affect position, repeatability or load distribution. The correct class is a compromise that depends on function, manufacturing capability, assembly method and service environment.
If the parts will be clamped after location, consider how the fastener pattern, datum scheme and clamping sequence influence the final position. The cylindrical fit may locate a component during assembly, but it does not independently determine the full geometric relationship of all features.
The table gives the five class pairings and a short description. It omits the full standard limit values and should not be used to create a tolerance callout by itself. Consult the current ASME publication for the nominal-size interval, deviations, clearances and other associated notes.
Verify the chosen fit against actual manufacturing and inspection methods. A hole made by drilling alone may not achieve the same size control as a bored or reamed hole. Likewise, shaft grinding, turning, plating and coating can change the final functional diameter.
NIST describes clearance and other fit behavior through the sign of the hole-minus-shaft gap. That calculation is useful as an independent check, but it does not replace the standard’s class selection or all dimensional requirements for a real assembly.
ASME lists B4.1-1967 (R2020) as reaffirmed and in effect. Confirm the required edition before releasing a drawing. Use this class index for orientation, then obtain the dimensional limits from the standard and have the responsible engineer validate the complete tolerance stack.
A class designation is useful only when the drawing and inspection plan use the same standard and size basis. Record the selected nominal interval and limit calculation with the tolerance stack, especially when the part locates another feature or assembly. Include the required edition, datum scheme, surface condition and measurement method in the released documentation so suppliers and inspectors evaluate the same functional limits.
Sources
ASME’s current listing for B4.1 describes preferred limits and fits for cylindrical parts. NIST IR 5615 explains the sign-based behavior of clearance and locational fits.
